![]() ![]() The Power light will tell you if you have set them or not. Move the crosshairs to each of the remaining squares. In the configuration mode, select Bank A by placing the crosshairs over the corresponding square and press any button. The Configuration light should stay on until you select the Config/Exit button again to exit the configuration mode.ģ. If this does not work, the digitizer may have a hardware problem. The Configuration light will go on and you will hear a beep. Set the digitizer up using its menu by placing the cursor crosshairs over the Config/Exit button and press any button. Some of the most common driver names include: WINTAB.COM, TABLET.COM, and CCMOUSE.COM.Ģ. If you loaded the Calcomp drivers in Windows, you need to uninstall them. Those drivers usually begin with "C:\CALDB\.". If you have loaded any their DOS drivers, you need to remove them from the AUTOEXEC.BAT and/or CONFIG.SYS files. Steps to configure a Calcomp DrawingBoard III digitizer with a 4-button puck.ġ. How To: Configure the Calcomp DrawingBoard III with 4-button puck Procedure ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |